INTRODUCTION
ELIFLON P-C30-000 IS A MEDIUM-LOW VISCOSITY CURE INCORPORATED COPOLYMER OF HEXAFLUOROPROPENE AND VINYLIDENE FLUORIDE. THIS GRADE OFFERS SIGNIFICANT PROCESSING EASE AND IT IS DESIGNED FOR INJECTION AND TRANSFER MOULDING.
P-C30-000 PROVIDES
- GOOD MOULD FLOW
- LOW MOULD FOULING
- EASY MOULD RELEASE
- VERY LOW COMPRESSION SET
- VERY HIGH ELONGATION
APPLICATION
- MOULDED GOODS, E.G. SHAFT SEALS
- CALENDERED GOODS
- O-RINGS, GASKETS, SEALS AND PROFILES
- EXTRUDED CORDS
USE AND PROCESSING PROCEDURES
ELIFLON P-C30-000 CAN BE COMPOUNDED WITH INTERNAL MIXERS OR TWO-ROLL MILLS USING TYPICAL FLUOROELASTOMERS FILLERS AND THE OTHER INGREDIENTS.
SAFETY AND HANDLING
DESPITE THE CHEMICAL INERTNESS AT AMBIENT TEMPERATURE, ELIFLON P-C30-000 SHOULD BE HANDLED IN SUCH A WAY TO AVOID CONTACT WITH SKIN AND EYES. IN CASE OF CONTACT, WASH THOROUGHLY WITH SOAP AND WATER. STORE IN A WELL-VENTILATED PLACE AWAY FROM ANY SOURCE OF HEAT. SMOKING IS STRICTLY FORBIDDEN IN WORKING AND STORAGE AREAS. IN THE EVENT OF FIRE, TOXIC GASES ARE PRODUCED. REFER TO MSDS FOR ADDITIONAL INFORMATION.
FOR THE SAFE HANDLING OF OTHER COMPOUND INGREDIENTS NORMALLY USED IN FLUOROELASTOMERS COMPOUNDING, PLEASE REFER TO THE RESPECTIVE MANUFACTURERS.
PRODUCT DESCRIPTION
 
COPOLYMER OF HEXAFLUOROPROPENE, AND VINYLIDENE FLUORIDE PLUS CURE CHEMICALS
66%
1,81 ± 0,03 G CM-3
OFF-WHITE
NONE
ETHERS AND KETONES
SLABS
30 ± 5 {ML 1+10 @121°C}